How to Measure a Window for Shades
You can preview shades in ViShade before you measure anything. When you are ready to request a quote, you will need the width and height of each window. This guide shows how to measure in a few minutes and how to avoid the most common mistakes.
Your seller always confirms the final size before production. You can also ask them to measure on site. There is a box for that in your quote request.
What you need
- A steel tape measure. Cloth tapes stretch and give wrong numbers.
- A pencil and paper, or your phone's notes app.
- About five minutes per window.
Measure in inches. ViShade's form uses inches, to the nearest 1/8 inch. Do not use centimeters or feet.
Step 1: Choose inside or outside mount
Inside mount means the shade fits inside the window frame. It looks clean and shows the trim around the window. The frame needs enough depth for the shade's headrail, so check the depth with your seller.
Outside mount means the shade hangs on the wall or trim above the window and covers the whole opening. It can make a window look larger and block more light at the edges. It is also the choice when the frame is too shallow.
You can try both mounts on your own photo in ViShade before deciding.
Step 2: Measure the width
Inside mount: Measure the width inside the frame in three places: top, middle and bottom. Windows are rarely perfectly square. Write down the narrowest of the three.
Outside mount: Measure the width of the area you want to cover. Many guides suggest adding about 1½ inches on each side (about 3 inches in total) so the shade overlaps the opening and blocks more light and view. Your seller can advise on the overlap.
Step 3: Measure the height
Inside mount: Measure the height inside the frame in three places: left, center and right. Write down all three. Guides differ on which one to use, and your seller decides.
Outside mount: Measure from where the shade will be mounted to where you want it to end, usually the sill or a little below it.
Step 4: Write it down the right way
- Width first, then height. Swapping the two is one of the most common mistakes. On most standard windows, the height is larger than the width.
- Do not make deductions. Enter the exact numbers you measured. Your seller adjusts for the product.
- Measure every window, even if they look the same.
- Label each window by room and position, such as "Bedroom left".
Step 5: Enter it in ViShade
Open your project, select the window and enter the width and height in inches. Tick "I checked…" when you are done.
Common mistakes
- Using centimeters or feet. The form uses inches.
- Measuring only once. Measure in three places, because frames are rarely square.
- Swapping width and height. Width always comes first.
- Rounding. Write down the size to the nearest 1/8 inch.
- Measuring the old blind instead of the window. Measure the window opening or the area you want to cover.
Not sure? Let the seller measure
You can skip measuring and ask the seller to measure on site. In your quote request, tick "I would like the supplier to measure on site before production." Either way, the supplier confirms the final measurements before your order.
See It in Your RoomHelp: Measuring
Quick answers
Can I preview shades before measuring? Yes. Measurements are only needed when you request a quote.
Does ViShade measure my window from the photo? No. The marked area in your photo guides the preview only. It is not a measurement.
What about sliding doors? Measure the same way. Most sliding doors are about 80 inches tall. If your height is much smaller, measure it again.